Jump to content

Looking for a cad drawing of the panel layout


Recommended Posts

Are you cutting foam for the bulkhead or metal for your final IP overlay?  If an overlay, you should plot out a trial run on paper and then cut it out to check for proper fit before sending it off for cutting.

Most of our IP’s can be off a little bit... plenty enough to make a difference.

  • Like 1

Andrew Anunson

I work underground and I play in the sky... no problem

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Create New...

Important Information