Jon Matcho Posted August 27, 2018 Share Posted August 27, 2018 This bit was my friend this weekend (a 3/8" 80-grit flap wheel). I was able to get up close and accurate sanding between my fiberglass work and plexiglass without any worries over taking too much material away. Quote Jon Matcho Builder & Canard Zone Admin Now: Rebuilding Quickie Tri-Q200 N479E Next: Resume building a Cozy Mark IV Link to comment Share on other sites More sharing options...
Voidhawk9 Posted August 28, 2018 Share Posted August 28, 2018 Interesting. Does it respond well to varying pressure? Quote Aerocanard (modified) SN:ACPB-0226 (Chapter 8) Canardspeed.com (my build log and more; usually lags behind actual progress)Flight simulator (X-plane) flight model master: X-Aerodynamics (GMT+12) Link to comment Share on other sites More sharing options...
Jon Matcho Posted August 28, 2018 Author Share Posted August 28, 2018 Yes, was quite good for that compared to a solid cutting wheel/disc/stone/drum. I use sanding drums all the time, but this was the first time I tried this. I didn't do a thorough inspection, but I think they wear out by just losing radius. Quote Jon Matcho Builder & Canard Zone Admin Now: Rebuilding Quickie Tri-Q200 N479E Next: Resume building a Cozy Mark IV Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.