gullikson Posted November 19, 2008 Share Posted November 19, 2008 Looking for suggestions on covering the 2.25" dia holes used to access the wing attach bolts in the centersection spar. I suppose I could just silicone a thin cover over these holes or install a couple of click bond nutplates with a cover. What's been done? Quote Link to comment Share on other sites More sharing options...
Waiter Posted November 19, 2008 Share Posted November 19, 2008 I used a .025 aluminum approximately 2 1/2 x4 inches, painted white. I then used a small dab of white RTV all the way around to hold it in place. Make sure the covers on the bottom have a small breather/drain hole. These can be popped off for inspection/wing removal, then just re-RTV them back in place Waiter Quote F16 performance on a Piper Cub budget LongEZ, 160hp, MT CS Prop, Downdraft cooling, Full retract visit: www.iflyez.com Link to comment Share on other sites More sharing options...
gullikson Posted November 19, 2008 Author Share Posted November 19, 2008 I used a .025 aluminum approximately 2 1/2 x4 inches, painted white. I then used a small dab of white RTV all the way around to hold it in place. Make sure the covers on the bottom have a small breather/drain hole. These can be popped off for inspection/wing removal, then just re-RTV them back in place Waiter Thanks Waiter. Kind of what I was thinking too. Best to keep it simple and light. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.