Big Steve Posted April 1, 2008 Posted April 1, 2008 I am presently building my turtle back. All is going well I had not seen anyone else do this so I thought I would take a picture. You know kind of a show and tell. It worked well for me. I used some long pins to hold down areas that were a little different in height. I slid the pins in at a very slight angle while holding the offending piece of foam in the right position. If you like it use it if not Well I tried. STeve http://websites.expercraft.com/bigsteve/images/105197164147f1a4362b4fc.jpg Quote Steve Harmon Lovin Life in Idaho Cozy IV Plans #1466 N232CZ http://websites.expercraft.com/bigsteve/ Working on Chapter 19,21
Edge 513 Posted April 1, 2008 Posted April 1, 2008 Yow. Thats some serious snot you're attaching that wood together with! I think the pins are a good one. Gets the job done. Quote Self confessed Wingnut. Now think about it...wouldn't you rather LIVE your life, rather than watch someone else's, on Reality T.V.? Get up off that couch!!! =) Progress; Fuselage on all three, with outside and inside nearly complete. 8 inch extended nose. FHC done. Canard finished. ERacer wings done with blended winglets. IO540 starting rebuild. Mounting Spar. Starting strake ribs.
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.