ULPower News Posted May 17, 2021 Share Posted May 17, 2021 In 2020 a service bulletin about a possible oil weep through the hall sensors was launched. Field reports have shown that the 10Nm that were initially mentioned in the SB, will be too much for the studs that hold the hall sensors. In order to prevent damage to the engine casing, the torque values have been rectified to 6 Nm. Please only take into account the current version of SB2020-02 RECTIFIEDView the full article Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.