Jump to content

Quoting and Replying with the new software

Recommended Posts

On 7/24/2018 at 10:16 PM, Marc Zeitlin said:

OK, so new the forum software doesn't easily allow for reasonable in-line reply formatting. Or if it does, it's not clear how to do it.

There does appear to be an interface/functional issue or two with quoting and replying, but here are a few tricks:

1) Before quoting and replying, click in the Reply area and press [Enter] a few times to open up some space (if text pre-populates from a prior reply, look for a "clear text" link in the reply area.

2) Scroll up to the post you want to reply, and press the Quote link there.  Remove all the stuff in the quote that you don't want to reply to and then construct your reply.

3) If you want to quote-and-reply to a different section within the original post, scroll up and click the Quote link again and repeat steps 2-3 until you're satisfied.

On 7/24/2018 at 10:16 PM, Marc Zeitlin said:

Great. Onward.

Yep, it's definitely different.  We'll get used to it while the software is improved as well.

Jon Matcho :busy:
Builder & Canard Zone Admin
Now:  Rebuilding Quickie Tri-Q200 N479E
Next:  Resume building a Cozy Mark IV

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Create New...

Important Information