Cozy Parts: CNC Canard Cores, Main Gear, Nose Strut, etc

[GuinnessGuy74]

After a 3 month break, I have started up again....only to call it quits. I will not bore you all with my story, but I cannot afford to build this aircraft anymore. I am selling the cozy parts that I have and my tub (complete through chap 6). Here is what I have:

 

1 tub - Complete through Chapter 6 (minus the firewall).

1 set of plans #1565, marked only with updates/corrections

1 Eureka CNC cut Canrad Core (still in box, never opened)

1 Featherlite Main Gear (still wrapped with nose strut, the way it came off the truck)

1 Featherlite Nose Strut

1 Firgelli Automation 4" 150lb linear actuator (speed brake)

Approx 75 yds BID

Approx 35yds UNI

1.5 Gallons MGS 335

2 quarts Hardener (1 fast, 1 slow)

Approx .5 lbs Micro

Approx 3lbs Flocked Cotton

 

 

I am located in the Charlotte, NC area. I have about $3500 in materials and parts. I am asking a humble $2000 for everything. I will consider selling off the parts seperately. A good chance for a builder to save some $$$ and get a headstart. I will post some pictures of the tub later. Email me at [email protected] if you are interested...

 

Regretfully,

Jim

[GuinnessGuy74]

I made a typo in the above post. The BID roll is approx 35 yards, not 75. Sorry about that!

 

Jim

[DWalker]

I am very interested- its easiest to reach me via phone- give me a call at 720-212-5838 or by email at [email protected]

[GuinnessGuy74]

I still have the following available:

 

Eureka Canard Core - $225

 

Approx 35 yds BID

Approx 35yds UNI

1.5 Gallons MGS 335

2 quarts Hardener (1 fast, 1 slow)

Approx 1 lbs Micro

Approx 3lbs Flocked Cotton

 

Composite materials above for $425

 

Thanks,

Jim

[tbatch2000]

Will the nose wheel strut work on a long ez?

 

Thanks

Rich

[GuinnessGuy74]

Everything is sold!

 

Sorry for the delay...

 

Jim