Varieze Mike Posted May 2, 2006 Share Posted May 2, 2006 To All, My oil breathe hose right now leaves the crankcase vent and goes up to the rear and loops back down the center line of the case torward the carbon spinner. This makes a mess of the spinner. I have hal Hunt four pipe exhaust. I was thinking about moveing this to the right out board exhaust pipe end . Should I use 5/8" 3003 aluminum or 5/8"304 stainless stell tubing? Any ideas, or proven methods in practice. Quote Link to comment Share on other sites More sharing options...
borrisl Posted June 4, 2018 Share Posted June 4, 2018 (edited) I have the same exhaust and had the same issues. I plugged the original breather, built a plate that covers where the starter goes, tapped a breather fitting on it. Then, oil separator on the firewall with an exhaust across the engine to the exit. Can kind of see the plate on the left back of the engine: Edited June 4, 2018 by borrisl Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.