Flying_Dutchman Posted August 19, 2005 Share Posted August 19, 2005 I just started chapter 9 and found out that Wicks sent me 3/8" thick 2024-T3 instead of 1/4" thick. I can see on the plans that some washers are used to center the main gear. I wonder if I might still make the MG2 out of 3/8" thick or do I need to wait for the new aluminum to come in? Ron Breukers Cozy Mk IV # 1214 Quote Link to comment Share on other sites More sharing options...
Wayne Hicks Posted August 19, 2005 Share Posted August 19, 2005 Take a look at the full-sized M drawings and see how much space is there. I don't recall off hand if 3/8th inch spacers will or won't work. But holding them to the drawing should tell you. Keep in mind that your 90-layer tabs may be thicker or thinner than what's shown on the M-drawing. Quote Wayne Hicks Cozy IV Plans #678 http://www.ez.org/pages/waynehicks Link to comment Share on other sites More sharing options...
Flying_Dutchman Posted August 19, 2005 Author Share Posted August 19, 2005 Actually that is just what I did, and it looked quite close. Maybe yes, but maybe no?? In the mean time Wicks came through with their great service again and they have shipped today (at no cost to me) a new shhet of aluminum. I guess I will take no chances and wait for it to come in. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.