bhassel Posted September 10, 2006 Share Posted September 10, 2006 I've gotten the seatback done with acceptable results, now I'm on to building the forward bulkheads and IP bulkheads. My chapter 4 & 5 kit from Wicks contains 4 sheets of tan .2 " (I think - need to order tha tape measure with the next chapter - thought I had one) foam that is 48 " x 12". Out of that I need to make both of the above mentioned bulkheads. Is there a preferred layout/cutout method? I checked multiple web sites and haven't apparently hit the correct one yet to show me the cuts to make. Most show the bulkhead foam already put together. I guess this will show me what to take pictures of for my web site! Bob Quote Bob Hassel Cozy Plans #749 Santa Fe, NM http://www.cozyworld.net http://www.hassel-usa.com Link to comment Share on other sites More sharing options...
Remi Khu Posted September 10, 2006 Share Posted September 10, 2006 Look at Chapter 2 page 5. There are great information in the often skimped through chapters 2 and 3. Quote Remi Khu Cozy Mk IV Plan #1336 Link to comment Share on other sites More sharing options...
bhassel Posted September 10, 2006 Author Share Posted September 10, 2006 Thanks Remi! I knew I had seen it somewhere. I kept looking in the back of the plans. Oh, well I'm going to print out that page and hang it on the wall in the garage. I think I'll be using that in the future! Bob Quote Bob Hassel Cozy Plans #749 Santa Fe, NM http://www.cozyworld.net http://www.hassel-usa.com Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.