td_howard Posted August 3, 2003 Share Posted August 3, 2003 This will probably only be of interest to brand-new builders/lurkers... Have seen in the archives/builder web sites several solutions to the problem of keeping your jig table level, usually using some variation of a nut+bolt embedded into the table leg. Happened to be browsing Lee Valley Tools (one of my favourite hangouts - if I had a gazillion bucks I would get at least one of everthing there... ). Saw these cool leg-leveller thingys that I will use for my table. They are rated at 2000lb apiece, and you can adjust them using a hex wrench from above. Plus, they have a rubber foot so if you need to move your table, you won't scuff up your floor. http://www.leevalley.com/hardware/page.asp?page=41865&category=3,40993,41283&abspage=1&ccurrency=2&SID= Quote Trevor Howard Edmonton, AB Canada COZY MKIV #1171 Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.